Laser cutting machine cutting section jagged reason analysis

Nowadays, the popularity of laser cutting machine has brought great progress to the sheet metal processing industry, and its advantages of high processing accuracy and smooth and burr-free section make it highly favored in the sheet metal related processing industry.laserpecker compact laser engraver Of course, this push and the popularity of the equipment is inseparable from the level of many laser cutting machine manufacturers.

Excellent level of manufacturing process and brand accessories are key factors in determining the quality of the equipment. However, many customers in the process of using the equipment will encounter the problem of jagged cutting section.laserpecker 11 So, how does this situation arise? The following laser will analyze in detail for you.

1. Vibration

If the laser cutting machine vibrates, then the products it cuts will appear jagged. This situation can be divided into two reasons. One is factors external to the machine, such as whether the water tank or extractor fan is too close to the machine during the cutting process. If they are too close, they will vibrate the machine when they are running, which in turn will affect the cutting edge.

2. Machine parallelism

If the parallelism of the machine is not installed properly, then it will not be smooth during operation. As a result, it will jitter during operation, leading to jaggedness in the cut product as well.

3. Lenses not locked

Sometimes, if the lenses are not locked, then the lenses will also vibrate during the operation of the machine. When the machine is cutting, the light will also vibrate, which will lead to poor quality of the cut product, the same will appear jagged.

4. Gear and pinion holders, etc.

If the edges of the gears gear holders are close to the holders, causing slippage etc., this can also lead to this situation.

5. Slider wear

Wear inside the slider or a lot of stuffing inside the bead of the slider will cause jerks when it runs on the guide. As a result, a lot of jagging occurs while cutting the material.

6. Guide rails not parallel

If the two guide rails in Y direction are not installed parallel, the machine will be stuck when it is running and there will be jaggedness when cutting.

If jagged teeth appear when cutting, you can hold the laser head by hand so that it does not jitter when running. If it doesn't jiggle when pressed, then it's a slider problem; if it still jiggles, then a belt and gear check is needed. If this happens when the machine is new, then it may be that it was not installed properly when it was installed, or the control drive and the motor do not match.

In conclusion, laser cutting machines play an important role in the sheet metal processing industry. In order to ensure the quality of cutting, we need to pay attention to the quality and operation details of the equipment. By understanding the above mentioned several possible causes of jaggedness, we can better solve this problem and improve the cutting effect and product quality.